Tag: Half Wave

Working a few on 10m (28MHz) with a half wave vertical

28MHz has been in good shape recently, so I wanted to go out portable and try my end fed half wave parallel tuned circuit coupler as I have not tried it on 10m before. The band was in good shape (unlike the weather) and it seemed to work well. I managed to work some good DX whilst I was there, the log can be seen below.

November 2014 10m log

I also took a little video of me working VA3AQB – Alan in Canada. The coupler seemed to work well on 10m and with a bit more bandwidth than other bands, perhaps because very little capacitance was needed. I’m enjoying making the most of the higher bands whilst they are open! John.

Portable operating on 24MHz

I was operating portable on 12m (21MHz) today. It’s a band which I have hardly ever used, so I cut a half wave length of wire and used my End Fed Half Wave Coupler to match it at the base of the fibreglass pole. Conditions seemed good and I was able to work Chicago, Massachusetts, California, New York and Texas in a short time. Below is a short video and photo of the setup.

Operating on 12m beside the river Thames.

Operating on 12m beside the river Thames.

Portable on 40m with the End Fed Half Wave

I went out for a little bit of /P operating this afternoon for just over an hour as the weather was OK. Had a nice chat on 40m with some UK stations using the end fed half wave set up as a kind of sloper. The end was up 8m on a fibreglass pole just resting against a tree, and the feed end came down to a low tree branch and then into the coupler. It seemed to perform really well on TX and RX. Below is a little clip recorded by Dave M0TAZ. Running 100w from the Icom IC-7200.

Experimenting with an end fed half wave

I went down to the river Thames a couple of mile from home today for some portable operation and some experimenting with an end fed half wave antenna. I recently built a Parallel tuned coupler for feeding end fed half waves from 7-30MHz and this was tested on a few bands. I wanted to try 15m, but the band was full of contest stations due to the Scandinavian contest, so I cut a piece of wire for a 17m vertical. Below is some video took by Dave M0TAZ of me working Chris SM0OWX on 18MHz.

I have used the coupler on a few different bands now in various configurations with good results. I shall add a post with more results after some more tests and fine tuning soon. Here is a photo of the inside of the unit. 73 John.