My first 23cm 1297MHz contact!

I recently purchased a 23cm transverter from SG-lab. It’s a 145MHz IF with a L.O. frequency of 1152MHz (default; can be changed). Output power is 2w. Tonight, I had my first QSO on the 23cm band with it with two friends who both have the same transverter, G7UVW and M1GEO. I used a Yaesu VX-6 for the IF, but that went flat, so I switched to the Icom ID-51, which is set to record all QSO’s, so there is an MP3 below!

The transverter comes with a HB9CV antenna etched on a PCB which works really well. I had the ID-51 in one hand and the antenna in the other, holding it out the window. All three of us had the same setup holding the antenna out of or near a window. I first spoke to David G7UVW at 2.2 miles and then George M1GEO at 1.2 miles. Signals were good all round, although it seems the best signal between G7UVW and I was via reflecting off a school building opposite me (or something, the peak signal certainly wasn’t in his direction!).

We are all very happy with the result. I am now going to build a couple of Yagi antennas, look at getting a PA and try out some of the 1.3GHz UK Activity Contests in the summer.

23cm Transverter

My first couple of 23cm QSO’s using a 2w transverter and a handheld.

George M1GEO setup with the HB9CV on a broom stick boom!

The setup of George M1GEO with the HB9CV on a broom stick boom!

Update: The next day, George M1GEO took his transverter up to the 12th floor at UCL in central London. We made contact easily again both with 2w and a HB9CV antenna, over a distance of 14km.

4 Comments

Add a Comment
  1. hey that looks like fun !
    where does one buy that x-verter ?
    is there something for 13cm ?

    1. Hi Danie.
      I bought this from http://www.sg-lab.com/TR1300/tr1300.html
      Take a look. Regards, John.

  2. Where did you buy the transverter from? I found the website of the suplier but there was no store.

    1. Send the guy an email. You can arrange with him to pay by PayPal.

      73, John.

Leave a Reply

Your email address will not be published. Required fields are marked *